Filter
Top Products
4
Step 1: Move slide switch on bottom of the sensor to TEST. There are three sensitivity
settings: L (low), M (medium) and H (high). Low will be the least sensitive and
high will be the most sensitive. Approximate detection ranges are as follows:
L . ..... 30 feet (short range)
M . .... 40-50 feet (mid-range)
H. ..... 60 or more feet (maximum range)
NOTE: Temperature can affect the sensitivity of the motion sensor.
It may be necessary to readjust the sensitivity when there are
major temperature changes. Set sensitivity slide switch to
medium or “M”. See diagram (O).
Step 2: Turn on the power to fixture. Allow fixture to warm up approx-
imately two minutes before testing. (Lights may or may not
come on during warm-up period.This is normal.)
Step 3: Aim sensor head in desired position. NOTE: Maintain air
spacing between lamps and sensor head at least 1”. Make
sure sensor head is positioned with control switches facing
towards the ground.
Step 4: Walk across the detection zone at the farthest distance you
wish your detector to detect motion.
Step 5: Adjust sensitivity until you get desired results. For more range, aim sensor head
slightly upwards. For less range, aim sensor head slightly downward. Lights will
turn off four seconds after all motion stops.
Step 6: Move slide switch to four MIN (AUTO mode) or to one of the two NIGHT TIME ON
settings. At dusk, lights will operate in the AUTO or NIGHT TIME ON settings.
(Refer to page 6 for detailed descriptions of the different modes.)
The sensor and indoor alarm/lamp module must be set to the same house code number
for the system to work properly. When the outside motion sensor is activated, the indoor
alarm will sound (in 1, 2, 3, or 4 chirp intervals depending on the house code selected).
If there is a lamp plugged into the module, the lamp will come on and stay on for 10 min-
utes. More than one sensor can be used to activate an indoor alarm/lamp control mod-
ule. All outdoor sensors set to the same house code will activate ALL indoor alarm/lamp
modules that are set to the same house code number.
Indoor alarm/lamp control module operation guide (P)
House code selections on sensor head (O)
How to operate your fixture
1
2
3
4
TEST
AUTO
2 HR
4 HR
SENSITIVITY
H
M
L
Switch setting: Tones: Indoor lamp:
AUTO
Number of beeps based
on house code setting
(fixture house code must
be same as module
house code)
Daytime:Off
Nighttime: On for
10 minutes
LAMP ON
Number of beeps based
on house code setting
(fixture house code must
be same as module
house code)
On
TEST
Number of beeps based on
house code setting of the
fixture (fixture house code
does not have to be same
as module house code)
When Mode of Operation switch is
moved, lamp stays on 10 minutes.
Lamp will turn on for 10 minutes
at night if motion is detected. If fix-
ture detects motion at Night or Day
alarm will chime.
OFF Off (No tones) Off (No light)
O
MS249R_MS249RW 325-1486.qxd 6/20/06 4:02 PM Page 4