Filter
Top Products
9
099494
Safety Precautions
2. Should the tool fail to fire, hold the muzzle firmly against the work surface for
30 seconds. Release the trigger and remove pressure on the tool while
holding the muzzle against the work surface. Again press the tool firmly
against the work surface and pull the trigger. If the tool still fails to fire, hold
the tool firmly against the work surface for another 30 seconds before
advancing the power load strip. Use remaining loads in strip. Discard power
load strip into water or oil.
30
WATER
GASOLINE
GAS
OLINE
482-50
3. Always use the spall shield when driving directly into concrete or steel. Always
wear approved goggles.
4. Never use a powder actuated tool in an explosive or flammable atmosphere or
when non-sparking tools are required.
POWER LOADS AND FASTENERS
1. Never leave unfired power load strips on floors or work surfaces.
482-49
Spall
Sheild
POWDER
LOADS
POWDER
LOADS