Filter
Top Products
8
106763
TOO THIN
WELD
G 018
3/16" MIN
1/2"
1"
Safety Precautions
7. DO NOT drive power fasteners into steel base material less then 3/16" thick,
within 2" of a weld, within 1/2" of the edge or within 1" of another power fastener.
3"
3"
3"
6. DO NOT drive power fasteners into concrete less than three times as thick as
the intended fastener penetration, within 3" of the edge, within 3" of another
power fastener or within 3" of a failed power fastener.
3"
3X
1X
8. When fastening into masonry walls, always drive into horizontal mortar joints,
never into vertical mortar joints. BE CAREFUL. A poorly laid joint may permit
too much penetration, and/or unsatisfactory holding power.
G 018
OPERATING THE TOOL
1. ALWAYS hold tool perpendicular to work surface.