Filter
Top Products
14
WARNING:
Do not use the dust collection bag when sanding
metal. Using the dust collection bag when sanding
metal creates a fire hazard, which could damage
the tool and lead to serious personal injury.
DUST BAG
See Figure 9.
The dust bag provides a dust collection system for the
sander. It should be installed over the exhaust hole located
on the side of the sander. For more efficient operation, empty
dust bag when half full.
Do not connect sander to power supply before installing
dust bag.
To install/remove dust bag:
Unplug the sander.
Place the opening of dust bag over dust exhaust of the
sander.
DUST BAG
DUST
EXHAUST
DUST BAG
OPENING
OPERATION
Fig. 9
EMPTYING THE DUST BAG
See Figure 10.
For more efficient operation, empty dust bag when no more
than half full. This will permit the air to flow through the bag
better. Always empty and clean the dust bag thoroughly
upon completion of a sanding operation and before placing
the sander in storage.
WARNING:
Collected sanding dust from sanding surface
coatings such as polyurethanes, linseed oil, etc.,
can self-ignite in the sander dust bag or elsewhere
and cause fire. To reduce the risk of fire, always
empty the dust bag frequently while sanding. Never
store or leave a sander without totally emptying its
dust bag. Also follow the recommendations of the
coatings manufacturers.
To empty the dust bag:
Unplug the sander.
Remove dust bag from sander.
Open zipper.
Shake out dust.
Replace dust bag on sander.
DUST BAG
Fig. 10
zIPPER