Filter
Top Products
10
®
�
®
OPERATION
TO INSTALL BLADE
See Figure 2.
n Unplug the saw.
WARNING:
The tool should never be connected to a power
supply when you are assembling parts, making
adjustments, cleaning, performing maintenance, or
when the tool is not in use. Disconnecting the tool
will prevent accidental starting that could cause
serious injury.
n Lift blade clamp lock/release lever located on side of
saw.
n Insert saw blade between blade clamp and saw bar.
NOTE: Blade can be installed with teeth facing either up
or down.
n Lower blade clamp lever to lock position.
BASE ASSEMBLY
The base assembly of the reciprocating saw pivots up and
down in both directions. The base is adjustable, allowing the
use of the blade teeth at different positions on the blade.
TO CHANGE POSITIONS OF THE BASE
ASSEMBLY
See Figures 3 - 4.
n Unplug the saw.
n Remove hex key from the hex key storage in the
handle.
n Loosen the screws in the gear frame with the hex key.
n Reposition base assembly.
n Retighten screws securely. Do not overtighten screws
or use an aid with hex key.
n Remove hex key and replace in storage.
Fig. 2
Fig. 3
Fig. 4
BLADE
�
�
HEX KEY
BASE ASSEMBLY
BLADE CLAMP
LEVER