Filter
Top Products
22
45
30
15
22
2
1
50
MAINTENANCE
CHECKING/REPLACING EXTERNAL
BRUSHES
See Figure 25.
NOTE:
The saw is equipped with externally accessible
brushes.
Unplug the saw.
WARNING:
Failure to unplug the tool could result in accidental
starting causing possible serious injury.
NOTE: Brush caps (2) are located on each side of the
motor housing.
Remove brush caps (2) using a screwdriver.
Remove brush assemblies (2).
Check for wear. Replace both brush assemblies when
either has less than 1/4 in. length of carbon remaining.
NOTE: Do not replace one side without replacing the
other.
Reassemble using new brush assemblies. Make sure
curvature of brush matches curvature of motor and that
brush moves freely in brush tube.
Reassemble by reversing the steps listed above.
Tighten all brush caps securely. Do not over tighten.
Fig. 25
BRUSH
CAP
BRUSH
ASSEMBLY
BRUSH CAP
BRUSH
ASSEMBLY
Look for these accessories where you purchased this product:
� Edge Guide ...................................................................................................................................................... 631697001
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
ACCESSORIES