Filter
Top Products
10
OPERATION
ADJUSTING THE AUXILIARY HANDLE
ASSEMBLY
See Figure 2.
Unplug the drill.
Loosen the auxiliary handle assembly by turning the handle
counterclockwise.
Rotate the auxiliary handle assembly to the desired
location.
Tighten the auxiliary handle assembly securely by turning
the handle clockwise.
SWITCH
See Figure 3.
To turn the drill ON, depress the switch trigger. Release the
switch trigger to turn the drill OFF.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE)
See Figure 4.
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the drill
held in normal operating position, the direction of rotation
selector should be positioned to the left of the switch trigger
for drilling. The drilling direction is reversed when the selector
is to the right of the switch trigger.
CAUTION:
To prevent gear damage, always allow the chuck
to come to a complete stop before changing the
direction of rotation.
To stop the drill, release the switch trigger and allow the
chuck to come to a complete stop.
NOTE: The drill will not run unless the direction of rotation
selector is pushed fully to the left or right.
Avoid running the drill at low speeds for extended periods
of time. Running at low speeds under constant usage may
cause the drill to become overheated. If this occurs, cool the
drill by running it without a load and at full speed.
Fig. 2
Fig. 3
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE)
SWITCH TRIGGER
Fig. 4
AUXILIARY HANDLE
ASSEMBLY
TO TIGHTEN
TO LOOSEN