Filter
Top Products
12
OPERATION
TO INSTALL BATTERY PACK
See Figure 4.
Lock the switch trigger on the drill by placing the
direction of rotation selector in center position.
Place battery pack in the drill. Align raised rib on battery
pack with the groove inside the drill.
Make sure the latches on each side of the battery pack
snap in place and battery pack is secured in the drill
before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the slide on
the bottom of the drill and latches snap into place
properly. Improper assembly of the battery pack
can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 4.
Lock the switch trigger on the drill by placing the
direction of rotation selector in center position.
Locate latches on side of battery pack and depress to
release battery pack from the drill.
The battery pack will automatically disconnect in
direction to be removed when buttons are depressed.
Remove the battery pack from the drill.
Fig. 4
DEPRESS LATCHES TO
RELEASE BATTERY PACK
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
SWITCH TRIGGER
See Figure 5.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed and
torque with increased trigger pressure and lower speed with
decreased trigger pressure.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
Fig. 5
SWITCH TRIGGER
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
FORWARD
REVERSE