RIDGID R83001 Drill User Manual


 
13
REVERSIBLE
See Figure 4.
This tool has the feature of being reversible. The direction of
rotation is controlled by a selector located above the switch
trigger. With the drill held in normal operating position, the
direction of rotation selector should be positioned to the left
of the switch for drilling. The drilling direction is reversed
when the selector is to the right of the switch. When the
selector is in center position, the switch trigger is locked.
CAUTION:
To prevent gear damage, always allow chuck to
come to a complete stop before changing the
direction of rotation or the two speed gear train
(hi-lo).
To stop, release switch trigger and allow the chuck to come
to a complete stop.
TWO-SPEED GEAR TRAIN
See Figure 7.
Your drill has a two-speed gear train designed for drilling or
driving at LO (1) or HI (2) speeds. A slide switch is located on
top of your drill to select either LO (1) or HI (2) speed. When
using drill in the LO (1) speed range, speed will decrease
and unit will have more power and torque. When using drill
in the HI (2) speed range, speed will increase and unit will
have less power and torque. Use LO (1) speed for high power
and torque applications and HI (2) speed for fast drilling or
driving applications.
AUXILIARY HANDLE
See Figure 8.
An auxiliary handle is packed with the drill for ease of op-
eration and to help prevent loss of control.
To use the auxiliary handle:
n Open the clamping ring by turning the handle counter-
clockwise.
n Slide the ring of the auxiliary handle onto the spindle col-
lar of the machine behind the torque adjustment ring.
n Tighten the auxiliary handle at the desired angle by turn-
ing the handle clockwise.
Note: For convenience the screw has been trapped inside
the auxiliary handle.
To prevent thread damage and possible loss of control, the
auxiliary handle should be checked periodically for tightness.
Do not operate the drill with the handle loose.
HI
SPEED
LO
SPEED
TWO SPEED
GEAR TRAIN (HI-LO)
1
Fig. 7
OPERATION
2
Fig. 8
TO
TIGHTEN
AUXILIARY
HANDLE ASSEMBLY
TO
LOOSEN