Filter
Top Products
20
21
POSITIVE 0° BEVEL STOP
See Figure 22.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0° angle of the saw blade when making
90° cuts.
TO CHECK
n Remove battery pack from saw.
WARNING:
Failure to remove battery pack from saw could
result in accidental starting, causing possible
serious personal injury.
n Place the saw in an upside down position on work-
bench.
n Using a carpenter’s square, check squareness of saw
blade to the base of the saw.
TO ADJUST
n Remove battery pack from saw.
n Loosen bevel adjustment knob.
n Loosen hex nut securing adjustment screw.
n Turn screw and adjust base until square with saw
blade.
n Tighten hex nut and bevel adjustment knob securely.
WARNING:
Attempting to make cuts without bevel adjustment
knob securely tightened can result in serious
injury.
OPERATION
Fig. 22
1
2
3
45
0
POSITIVE 0º
BEVEL STOP
BEVEL
ADJUSTMENT
KNOB
HEX NUT
ADJUSTMENT
SCREW
CARPENTER’S
SQUARE
BLADE