Filter
Top Products
9
TO INSTALL BATTERY PACK
See Figure 2.
Lock the switch trigger on the drill by placing the direc-
tion of rotation (forward/reverse/center lock) selector in
center position.
Place battery pack in the drill. Align raised rib on battery
pack with the groove inside the drill.
Make sure the latches on each side of the battery pack
snap in place and battery pack is secured in the drill
before beginning operation.
TO REMOVE BATTERY PACK
See Figure 2.
Lock the switch trigger on the drill by placing the direction
of rotation selector in center position.
Locate latches on side of battery pack and depress to
release battery pack from the drill.
The battery pack will disconnect in direction to be re-
moved when latches are depressed.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
SWITCH TRIGGER
See Figure 3.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
See Figure 3.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
NOTE:
You might hear a whistling or ringing noise from the
switch during use. Do not be concerned; this is a normal
part of the switch function.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 3.
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the drill
held in normal operating position, the direction of rotation
selector should be positioned to the left of the switch trigger
for forward drilling. The drilling direction is reversed when
the selector is to the right of the switch trigger.
Setting the direction of rotation selector in the OFF (center
lock) position will lock the switch trigger to help reduce the
possibility of accidental starting when not in use.
Fig. 2
DEPRESS
LATCHES TO
RELEASE
BATTERY PACK
OPERATION
Fig. 3
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
REVERSE
FORWARD
VARIABLE SPEED
SWITCH TRIGGER
Fig. 4
DRILL BIT
OPEN
(RELEASE)
CHUCK
JAWS
GRIP
(TIGHTEN)
KEYLESS
CHUCK