Filter
Top Products
34
Mounting Your Saw (continued)
Mounting Table Saw to RIDGID
Universal Power Tool Legset
#AC9910
1. Assemble legset per instructions.
2. Locate the four (4) “TS” layout points on
the particle board tables.
3. Drill the four (4) above holes.
4. Insert four (4) 1/4-20 screws that are
long enough for washers and nuts
which will properly secure the table saw
to the legset. Tighten hardware.
NOTE: Mounting hardware (bolts, nuts,
washers, etc.) are not supplied with the
saw.
Workbench Mounting Using "C"
Clamps
An alternative method of securing your
table saw is to fasten the saw base with
"C" clamps.
1. Follow instructions for mounting to
workbench, substitute "C" clamps at
each mounting screw location.
2. Securely clamp saw to workbench
using four "C" clamps, as shown.
Supporting surface where saw is to be
mounted should be examined carefully
after mounting to insure that no move-
ment can occur during use. If any tipping,
sliding or walking is noted, secure the
workbench or cabinet before operating
the table saw.
Supporting Table Saw with
Sawhorses
The table saw has provisions for being
supported by sawhorses. The sawhorse
can be built with the 2" x 4"crosspieces
either vertical or horizontal. Make sure the
sawhorses are secure. Holes for securing
unit to sawhorse(s) are provided.
"C" Clamps
(Front and Rear)
Mounting
Screw Location
Diagram of Clamping Table Saw
"C" Clamp
to Workbench