4. OPERATING YOUR ENGINE
-
7
-
ON
ON
OFF
Pull the starter handle slowly, until
resistance is felt.
This is the "compression" point.
Return the handle to its original
position and pull swiftly.
Do not pull out the rope all the way.
After starting the engine, allow the
starter handle to return to its origi-
nal position while still holding the
handle.
RECOIL STARTER
STARTING
1
Set the throttle lever to the idling
position.
If the stop switch is installed on the
engine.Set the stop switch to the
position "ON or I ".
If the stop switch is installed on a
machine side.Set the stop switch to
the position "ON or I ".
Close the choke lever.
If the engine is cold or the ambient
temperature is low, close the
choke
lever
fully.
If the engine is warm or the ambient
temperature is high, open the
choke lever half-way, or keep it
fully open.
STOP SWITCH
CHOKE LEVER
2
4
3
Push the primer pump 7 to 10 times
to feed the fuel to the carburetor.
PRIMER PUMP