Subaru Robin Power Products EX 27D Welder User Manual


 
US
PROCEDURE INTERVAL
1) Clean engine and check bolts & nuts : Every 8 hours (daily)
2) Check and refill engine oil : Every 8 hours (refill daily up to upper limit)
3) Change engine oil : Initial 20 hours and every 100 hours afterward
4) Clean spark plug : Every 50 hours (weekly)
5) Clean air cleaner : Every 50 hours (weekly)
6) Replace air cleaner element : Every 200 hours (monthly)
7) Clean fuel filter : Every 200 hours (monthly)
8) Clean and adjust spark plug and electrodes : Every 200 hours (monthly)
9) Replace spark plug : Every 500 hours
10) Remove carbon from cylinder head : Every 500 hours
11) Check and adjust valve clearance : Every 500 hours
12) Clean and adjust carburetor : Every 500 hours
13) Replace fuel lines : Every 1000 hours (yearly)
14) Overhaul engine : Every 1000 hours
Note: More frequent maintenance may be necessary under dusty, dirty or severe conditions.
When warranty repair is needed, the engine must be brought to an
authorized service dealer or warranty station’s place of business during
normal business hours. In all cases, a reasonable time, not to exceed
30 days, must be allowed for the warranty repair to be completed after
the engine is received by the authorized service dealer or warranty station.
G. MAINTENANCE, REPLACEMENT AND
REPAIR OF EMISSION-RELATED PARTS
Only warranted engine replacement parts approved by FUJI should
be used in the performance of any warranty maintenance or repairs
on emission-related parts. If other than authorized parts are used for
maintenance, replacement or repair of components affecting emission
control, you should assure yourself that such parts are warranted by
their manufacturer to be equivalent to authorized parts in performance
and durability. FUJI ,however, assumes no liability under this warranty
with respect to parts other than authorized parts. The use of non-
authorized replacement parts does not invalidate the warranty on
other components unless the non-authorized parts cause damage to
warranted parts.
I. MAINTENANCE STATEMENTS
It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2002 and later
Owner's Manual and to retain proof that inspection and maintenance services are performed at the times when recommended. FUJI will not
deny a warranty claim solely because you have no record of maintenance; however, FUJI may deny a warranty claim if your failure to perform
required maintenance resulted in the failure of warranted part. The proof which you maintain should be given to each subsequent owner of the
engine. You are responsible for performing the scheduled maintenance described below based on the procedures specified in the 2002 and
later Owner's Manual. The scheduled maintenance below is based on a normal engine operating schedule.
H. PARTS COVERED UNDER THE CALIFORNIA EMISSIONS
WARRANTY
(1) Fuel Metering System
(i) Carburetor and internal parts (and/or pressure regulator or
fuel injection system).
(ii) Air/fuel ratio feedback and control system, if applicable.
(iii) Cold start enrichment system, if applicable.
(iv) Regulator assy (gaseous fuel, if applicable)
(2) Air Induction System
(i) Intake manifold, if applicable
(ii) Air filter.
(3) Ignition System
(i) Spark plugs.
(ii) Magneto or electronic ignition system.
(iii) Spark advance/retard system, if applicable.
(4) Exhaust manifold, if applicable
(5) Miscellaneous Items Used in Above Systems
(i) Electronic controls, if applicable
(ii) Hoses, belts, connectors, and assemblies.
(iii) Filter lock assy (gaseous fuel, if applicable)