Filter
Top Products
4
WARNING:
Never stand directly in line with the blade or allow hands
to come closer than 3 in. to the blade. Do not reach
over or across the blade. Failure to heed this warning
can result in serious personal injury.
ASSEMBLY
n Lower the blade below the table surface.
n Loosen the screws and remove the throat plate.
n Remove the blade and blade guard assembly following
instructions in the table saw Operator's Manual.
n Included with the dado set are installation instructions.
Follow these instructions to install the dado set.
NOTE: The spacer/washer should only be used with a
regular blade.
NOTE: When using 5/8 in. width dado set use flange nut
and flange/spacer.
n Place dado insert on the table saw as shown in figure 1.
n Securely tighten using screws provided.
APPLICATIONS
You may use this tool for the purposes listed below:
n For cutting up to 5/8 in. maximum width dadoes on BTS15
Ryobi table saw.
WARNING:
Always use push sticks or push blocks when making
non-through cuts to avoid the risk of serious injury.
Never feed wood with your hands.
n Follow all dado instructions.
n When the work is complete, turn the saw off, remove the
switch key, and unplug the saw.
n Lower the blade below the table surface.
WARNING:
Lower the blade to prevent possible injury.
n Remove the dado insert and dado set.
n Reinstall the blade, blade guard assembly, and throat plate
following instructions in the BTS15 Operator's Manual.
WARNING:
To reduce the risk of injury and before plugging the
saw back in, make sure the blade guard is installed
and working properly.
TABLE TOP
DADO INSERT
SCREWS
Fig. 2
OPERATION
WARNING:
Never install a dado set to cut a larger groove than a
width of 5/8 in. Installing a wider dado set could result
in insufficient thread engagement of the arbor nut.
Never use any blade or dado set with less than full
engagement of the nut on the threaded arbor shaft.
Insufficient thread engagement could result in the blade
or dado loosening on the arbor shaft and could result in
serious personal injury.
USING A DADO INSERT
n Make sure the wood is not touching the blade. Plug in the
saw, insert the switch key, and turn the saw on. Let the
saw build up to full speed before feeding the workpiece
into the blade. Always use push sticks or push blocks
with any non-through cuts.
NOTE: Never use this dado throat plate with a dado set
larger than 6 in..