Filter
Top Products
Page 7
With the exception of the side handle and grinding wheel,
your angle grinder has been shipped completely assembled.
Carefully remove the grinder and accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect grinder carefully to make sure no breakage or
damage has occurred during shipping.
If any parts are damaged or missing, contact your nearest
Ryobi dealer to obtain replacement parts before
attempting to operate grinder.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated grinder.
PACKING LIST
Angle Grinder With Guard
Grinding Wheel
Side Handle
Wrench
Operator's Manual
Warranty Registration Card
WARNING:
If any parts are missing, do not operate your grinder until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.
UNPACKING
ELECTRICAL
ELECTRICAL CONNECTION
Your grinder has a precision built electric motor. It should be
connected to a power supply that is 120 volts, 60Hz, AC
only (normal household current). Do not operate this tool
on direct current (DC). A substantial voltage drop will cause
a loss of power and the motor will overheat. If your tool does
not operate when plugged into an outlet, double check the
power supply.
EXTENSION CORDS
When using a power tool at a considerable distance from the
power source, use an extension cord heavy enough to carry
the current that the tool will draw. An undersized extension
cord will cause a drop in line voltage, resulting in a loss of
power and causing the motor to overheat. Use the chart
provided below to determine the minimum wire size required
in an extension cord. Only round jacketed cords listed by
Underwriter's Laboratories (UL) should be used.
Length of Extension Cord Wire Size (A.W.G.)
Up to 50 16
51 to 100 14
When working with the tool outdoors, use an extension cord
that is designed for outside use. This is indicated by the
letters WA on the cord's jacket.
Before using an extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
CAUTION:
Keep the cord away from the cutting area and position
the cord so that it will not be caught on lumber, tools, or
other objects during cutting.