Filter
Top Products
12
USING THE DUST COLLECTION BAG
The dust collection bag provides a dust collection system
for the sander.
TO ATTACH THE DUST COLLECTION BAG
See Figure 9.
Follow these directions to attach the dust collection bag.
Unplug the sander.
WARNING:
Failure to unplug the tool could result in accidental
starting causing possible serious injury.
Slide the dust bag retainer over the blower exhaust
hole on the sander.
TO EMPTY THE DUST COLLECTION BAG
For more efficient operation, empty the dust collection
bag when it is no more than half full. This action permits
the air to flow through the bag better. Always empty and
clean the dust collection bag thoroughly upon completion
of a sanding operation and before placing the sander in
storage.
WARNING:
Collected sanding dust from sanding surface coat-
ings such as polyurethanes, linseed oil, etc. can self-
ignite in your sander dust collection bag or else-
where and cause fire. To reduce the risk of fire
always empty your dust bag frequently (10-15 min-
utes) while sanding and never store or leave a sander
without totally emptying its dust bag. Also follow the
recommendations of the coatings manufacturers.
Follow these directions to empty the dust collection bag.
Unplug the sander.
WARNING:
Failure to unplug the tool could result in accidental
starting causing possible serious injury.
Remove the dust collection bag from the sander.
Unzip the dust bag.
Shake out the dust.
Zip up the dust bag.
Replace the dust collection bag.
NOTE: Periodically, you should turn the dust bag
inside-out and thoroughly clean it.
OPERATION
Fig. 9
BLOWER
EXHAUST
HOLE
DUST BAG
RETAINER