Filter
Top Products
13
ASSEMBLY
go through holes in the saw base and material the saw is
being mounted to. If machine bolts are being used, make
sure bolts are long enough to go through holes in the saw
base, the material being mounted to, and the lock washers
and hex nuts.
NOTE: It may be necessary to countersink hex nuts and
washers on bottom side of mounting board.
MOUNTING THE SAW TABLE
See Figures 6 and 7.
Standing at the front of the band saw, slide the saw table
pass the blade and through the slot moving from the right
side of the saw table to the left.
Align the screw holes in the saw table with the holes in
the saw table bracket.
Using the phillips screws, attach the saw table to the saw
table bracket. Tighten phillips screws securely.
Attach the table aligning bolt, washer, and wing nut to
the saw table.
NOTE: The wing nut goes below the saw table.
WING
NUT
WASHER
TABLE
ALIGNING
BOLT
Fig. 7
LOCK
KNOB
BLADE GUIDE
KNOB
Fig. 6
SCREW
SAW
TABLE
SAW TABLE
BRACKET