Ryobi CSB121 Saw User Manual


 
11
ASSEMBLY
WARNING:
Your tool should never be connected to power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when not in
use. Disconnecting your tool will prevent accidental
starting that could cause serious injury.
WARNING:
7-1/4 in. (184 mm) blade is the maximum blade
capacity of your saw. Also, never use a blade that is
too thick to allow outer blade washer to engage with
the flat on the spindle. Larger blades will come in
contact with the blade guards, while thicker blades
will prevent blade screw from securing blade on
spindle. Either of these situations could result in a
serious accident.
ATTACHING BLADE
See Figures 2 and 3.
Follow these directions to attach the blade.
UNPLUG YOUR CIRCULAR SAW.
WARNING:
Failure to unplug the tool could result in accidental
starting causing serious injury.
Remove wrench from storage area.
CAUTION:
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging spindle lock.
Depress spindle lock button.
Remove blade screw by turning it counterclockwise
with the wrench.
Remove spring washer and outer washer
(“D” washer).
Wipe a drop of oil onto inner washer and outer
washer ("D" washer) where they contact blade.
WARNING:
If inner washer has been removed, replace it before
placing blade on spindle. Failure to do so could cause
an accident since blade will not tighten properly.
Fig. 2
Fit saw blade inside lower blade guard and onto
spindle.
NOTE: The saw teeth point upward at the front of
the saw as shown.
Replace “D” washer and spring washer.
NOTE: "Cupped" side of spring washer goes against
“D” washer.
Depress spindle lock and replace blade screw.
Tighten blade screw securely by turning it clockwise
with the wrench.
Return wrench to storage area.
NOTE: Never use a blade that is too thick to allow
the "D" washer to engage with the flat on the spindle.
Fig. 3
SPINDLE
BLADE
SCREW
SPRING
WASHER
OUTER
WASHER
(“D”
WASHER)
BLADE
INNER
WASHER
OUTER WASHER
(“D” WASHER)
CUPPED SIDE OF
SPRING WASHER
OUTSIDE OF SPRING
WASHER