Filter
Top Products
Page 11
OPERATION
NEVER PLACE YOUR SAW ON THAT PART OF THE
WORK THAT WILL FALL OFF WHEN THE CUT IS MADE.
See Figure 12.
Keep the cord away from cutting area. ALWAYS place the
cord to prevent it from hanging up on the work while making
a cut. Utilize the cord clip to help prevent cord problems.
See Figure 13.
DANGER:
If the cord hangs up on the work during a cut, release the
switch trigger immediately. Unplug your saw and reposition
the cord to prevent it from hanging up again.
DANGER:
Using your saw with a damaged cord will result in serious
injury or death. If the cord has been damaged, have it
replaced before using your saw again.
Hold your saw firmly with both hands.
See Figure 14.
ALWAYS let the blade reach full speed, then guide your
saw into the work.
WARNING:
The blade coming in contact with the work before it
reaches full speed could cause your saw to "kickback"
toward you resulting in serious injury.en pressure. F
When making a cut, use steady, even pressure. Forcing
causes rough cuts, could shorten the life of your saw, and
could cause kickback.
REMEMBER: When sawing through work, the lower blade
guard does not cover the blade, exposing it on the
underside of work. Keep your hands and fingers away
from the cutting area.
After you complete your cut, release the trigger and allow
the blade to come to a complete stop. DO NOT REMOVE
YOUR SAW FROM WORKPIECE WHILE THE BLADE IS
MOVING.
Fig. 12
Fig. 13
Fig. 14
WRONG
CORD
CLIP
RIGHT
CAUTION:
When lifting your saw from the work, the blade is exposed
on the underside of your saw until the lower blade
guard closes. Make sure lower blade guard is closed
before setting your saw down on work surface. Failure
to do so may result in serious personal injury.
45
0