Filter
Top Products
Page 5
KNOW YOUR JIG SAW
See Figure 1.
Before attempting to use your saw, familiarize yourself with
all operating features and safety requirements.
OPERATION
CHIP SHIELD
A clear plastic chip shield is installed on the front of your
saw for protection against flying dust and chips. The flip-up
design of the chip shield makes installing and removing
blades easier. FOR YOUR PROTECTION, DO NOT USE
SAW WITHOUT CHIP SHIELD PROPERLY IN PLACE.
ELECTRICAL CONNECTION
Your saw has a precision built electric motor. It should be
connected to a power supply that is 120 volts, 60 Hz, AC
only (normal household current). Do not operate this tool
on direct current (DC). A substantial voltage drop will cause
a loss of power and overheating. If your tool does not operate
when plugged into an outlet, double-check the power supply.
Fig. 1
WARNING:
Do not allow familiarity with your saw to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
APPLICATIONS
(Use only for the purpose listed below)
1. Cutting wood surfaces.
2. Cutting thin sheet metal.
3. Cutting plastics and laminates.
WARNING:
If any parts are missing, do not operate your saw until the
missing parts are replaced. Failure to do so could result
in possible serious injury.
0
SAW BLADE
LOCK-ON BUTTON
HEX KEY STORAGE
COMPARTMENT
BLADE STORAGE
COMPARTMENT
SWITCH
TRIGGER
ORBITAL
ADJUSTMENT KNOB
BASE
CHIP
SHIELD
VARIABLE SPEED
CONTROL SELECTOR
1/8 in. HEX KEY