Ryobi MS180 Saw User Manual


 
19
4
5
3
0
1
5
0
15
2
2
.5
30
45
4
5
31.62
22.5
31.62
45
3
0
15
0
1
5
22
.5
30
4
5
4
5
31.62
22.5
3
1
.6
2
ADJUSTMENTS
SQUARING THE SAW BLADE TO THE FENCE
See Figures 23 – 26.
Remove battery pack from saw.
WARNING:
Failure to remove battery pack from your saw
could result in accidental starting causing possible
serious personal injury.
Pull the saw arm all the way down and engage
the lock pin to hold the saw arm in transport
position.
Lift the miter table clamp.
Rotate the miter table until the pointer is posi-
tioned at 0°.
Push the miter table clamp back down.
Lay a framing square flat on the miter table. Place
one leg of the square against the fence. Slide the
other leg of the square against the flat part of saw
blade.
Note: Make sure that the square contacts the flat
part of the saw blade, not the blade teeth.
The edge of the square and the saw blade should
be parallel as shown in figure 23.
Fig. 23
MITER TABLE
VIEW OF BLADE
SQUARE WITH FENCE
BLADE
FENCE
Fig. 24
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
Using a 6 mm hex key, loosen the socket head
screws securing the fence.
See Figure 22.
Adjust
the fence left or right until the framing square and
throat plate are parallel.
Fig. 22
6 mm SOCKET
HEAD SCREW(S)
FENCE
Retighten the screws securely and recheck the
fence-to-table alignment.
FRAMING SQUARE
0
2
2
.5
30
15
31.6
2
2
.5
30
15
31.6
4 5
4 5
5
If the front or back edge of the saw blade angles
away from the square as shown in figures 24 and
25, adjustments are needed.
FENCE
MITER TABLE
FRAMING SQUARE
BLADE