Filter
Top Products
Page 23
3
0
4
5
31.62
OPERATION
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do so
could result in objects being thrown into your eyes,
resulting in possible serious injury.
After all parts have been assembled properly and
adjustments have been made to saw, battery pack
can now be attached to saw.
TO INSTALL BATTERY PACK
See Figure 32.
■ Place battery pack in your saw. Align raised rib on
battery pack with groove inside saw.
TO REMOVE BATTERY PACK
See Figure 32.
■ Locate latches on each side of battery pack and
depress to release battery pack from your saw.
■ Remove battery pack from your saw.
APPLICATIONS
(Use only for the purposes listed below)
■ Cross cutting wood and plastic.
■ Cross cutting miters, joints, etc. for picture frames,
moldings, door casings, and fine joinery.
Note: The carbide tipped blade provided is fine for
most wood cutting operations. For fine joinery cuts or
cutting plastic, use one of the accessory blades
available from your Ryobi dealer.
WARNING:
Before starting any cutting operation, clamp or bolt
your compound miter saw to a workbench. Never
operate your miter saw on the floor or in a
crouched position. Failure to heed this warning can
result in serious personal injury.
WARNING:
Do not attempt to operate this tool until you have
read thoroughly and understand completely all
instructions, safety rules, etc. contained in this
manual. Failure to comply can result in accidents
involving fire, electric shock, or serious personal
injury. Save operator's manual and review
frequently for continuing safe operation, and
instructing others who may use this tool.
Fig. 32
BATTERY
PACK
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
■ Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in
saw before beginning operation.
CAUTION:
When placing battery pack in your saw, be sure
raised rib on battery pack aligns with groove inside
saw and latches snap into place properly. Improper
assembly of battery pack can cause damage to
internal components.
WARNING:
Remove battery pack from tool when not in use,
changing blades, or making adjustments.