Filter
Top Products
11
20
24
5
OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack cool
down for approximately 30 minutes before attempting to
recharge. When the battery pack becomes discharged and
is hot, this will cause the green LED to come on instead of
the red LED. After 30 minutes, reinsert the battery pack in
the charger. If the green LED continues to remain on, return
battery pack to your nearest Ryobi Authorized Service Center
for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to CHARGING
A COOL BATTERY PACK for normal recharging of batter-
ies. If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorized Service Center
for electrical check.
TO INSTALL BATTERY PACK
See Figure 4.
n Place the direction of rotation selector in center
position.
�n Place the battery pack in the drill. Align raised rib on bat-
tery pack with groove in drill’s battery port.
�n Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in drill
before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the drill
and latches into place properly. Improper installa-
tion of the battery pack can cause damage to internal
components.
TO REMOVE BATTERY PACK
n Place the direction of rotation selector in center
position.
�n Locate latches on side of battery pack and depress both
sides to release battery pack from the drill.
�n Remove battery pack from the drill.
Fig. 2
P110
CHARGER
GREEN LED
YELLOW LED
RED LED
P100
BATTERY PACK
P110
CHARGER
Fig. 3
Fig. 4
BATTERY PACK SHOWN IN CHARGER
BATTERY PACK
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK