Filter
Top Products
12
OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack cool
down for approximately 30 minutes before attempting to
recharge. When the battery pack becomes discharged and
is hot, this will cause the green LED to come on instead of
the red LED. After 30 minutes, reinsert the battery pack in
the charger. If the green LED continues to remain on, return
battery pack to your nearest Ryobi Authorized Service Center
for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to “CHARGING
A COOL BATTERY PACK” for normal recharging of batter-
ies. If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorized Service Center
for electrical check.
TO INSTALL BATTERY PACK
See Figure 4.
n Lock the trigger switch by placing the rotation selector
in the center position.
n Place the battery pack on the tool.
n Make sure the latches on each side of the battery
pack snap into place and the battery pack is secured
on the tool before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the drill
and latches into place properly. Improper installa-
tion of the battery pack can cause damage to internal
components.
TO REMOVE BATTERY PACK
See Figure 4.
n Lock the trigger switch by placing the rotation selector
in the center position.
n Depress the latches on the side of battery pack.
n Remove the battery pack from the tool.
SWITCH
See Figure 5.
n To turn the drill ON, depress the switch trigger.
n To turn the drill OFF, release the switch trigger.
2 0
5
Fig. 4
BATTERY PACK
LATCHES
20
24
5
Fig. 5
DEPRESS LATCHES TO
RELEASE BATTERY PACK
TO TURN ON
TO TURN OFF