Filter
Top Products
6 — English
FEATURES
PRODUCT SPECIFICATIONS
Chuck .......................................................... 1/2 in. Keyless
Motor ..................................................................18 Volt DC
Switch ..........................................................Variable Speed
No Load Speed .......................0-400/0-1,500 r/min. (RPM)
Clutch.................................................................24 position
Torque ...................................................................330 in.lb.
Hammer Speed .............................0-5,200/0-19,500 BPM*
*Blows Per Minute
KNOW YOUR HAMMER DRILL
See Figure 1, page 13.
The safe use of this product requires an understanding of
the information on the tool and in this operator’s manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AUXILIARY HANDLE
Your drill is equipped with an auxiliary handle for ease of
operation and to prevent loss of control.
BIT STORAGE
Bits provided with the drill can be placed in the storage area,
located on the base of the drill.
BLOWS PER MINUTE
This tool features an impact speed of 0-5,200/0-19,500
BPM (Blows Per Minute). Blows Per Minute is the number
of impacts per minute.
DEPTH STOP ROD
A depth stop rod has been supplied with this product to
assist in controlling the depth of drilled holes.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
Your drill has a direction of rotation (forward/reverse/center
lock) selector located above the switch trigger for changing
the direction of bit rotation. Setting the switch trigger in the
OFF (center lock) position helps reduce the possibility of
accidental starting when not in use.
KEYLESS CHUCK
The keyless chuck allows you to hand-tighten or release the
drill bit in the chuck jaws.
LEVEL DRILLING
A level is located on the top of the hammer drill. It can
be used to keep drill bits level during horizontal drilling
operations.
MAGTRAY™
The magnetic tray conveniently stores screws or other small
parts.
QUICK MODE SELECTOR
The Quick Mode Selector allows you to quickly switch from
drive mode to drill mode.
TORQUE ADJUSTMENT RING
Your drill has a 24-position clutch. The torque adjustment
ring can be turned to select the right amount of torque for
the application.
TWO-SPEED GEAR TRAIN
The two-speed gear train is designed for drilling or driving
at LO (1) or HI (2) speeds. A slide switch is located on top
of the drill for selecting either LO (1) or HI (2) speed.
VARIABLE SPEED
The switch trigger delivers higher speed with increased
trigger pressure and lower speed with decreased trigger
pressure.