Filter
Top Products
12
Fig. 4
P110
CHARGER
YELLOW LED
RED LED
Fig. 5
P110
CHARGER
BATTERY
PACK
GREEN LED
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack cool
down for approximately 30 minutes before attempting to
recharge. When the battery pack becomes discharged and
is hot, this will cause the green LED to come on instead of
the red LED. After 30 minutes, reinsert the battery pack in
the charger. If the green LED continues to remain on, return
battery pack to your nearest Ryobi Authorized Service Center
for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to “CHARGING
A COOL BATTERY PACK” for normal recharging of batter-
ies. If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorized Service Center
for electrical check.
INSTALLING THE BATTERY PACK
See Figure 6.
n Lock the switch trigger by releasing it all the way.
n Place the battery pack on the tool.
n Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured on the
tool before beginning operation.
CAUTION:
When placing the battery pack on the tool, make sure
that the raised rib inside the tool aligns with the groove
on the battery pack and that the latches snap into place
properly. Improper assembly of the battery pack can
cause damage to internal components.
REMOVING THE BATTERY PACK
See Figure 6.
n Lock the switch trigger by releasing it all the way.
n Depress the latches on the side of battery pack.
n Remove the battery pack from the tool.
OPERATION
BATTERY PACK
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 6
BATTERY SHOWN ATTACHED TO CHARGER