Filter
Top Products
Page 7
OPERATION
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use any tool, familiarize yourself with all
operating features and safety requirements.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is sufficient
to inflict severe injury.
Note: A bit storage is located on the bottom of your drill and
also on the charger.
See Figures 1 and 2.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it prior to use.
Note: Batteries will not reach full charge the first time they are
charged. Allow several cycles (drilling followed by recharging)
for them to fully charge.
TO CHARGE
■ Charge battery pack only with the charger provided.
■ Make sure power supply is normal house voltage, 120
volts, 60 Hz, AC only.
■ Connect charger to power supply.
■ Place battery pack in charger aligning raised rib in charger
with groove in battery pack.
■ Press down on battery pack to be sure contacts on battery
pack engage properly with charger contacts. When properly
connected, red light will turn on.
■ When your battery pack becomes fully charged, the red
light will turn off and the green light will turn on.
■ After normal usage, 1 hour of charge time is required to be
fully charged. A minimum charge time of 1-1/2 hours is
required to recharge a completely discharged tool.
■ The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
■ DO NOT place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
■ When the batteries become fully charged, unplug your
charger from power supply and remove the battery pack.
CHARGING WITH CHARGER 1400677
See Figure 2.
If red light is flashing, this indicates battery pack is deeply
discharged or hot.
If battery pack is hot, red light should become steady after
battery pack has cooled down.
If battery pack is deeply discharged, red light should become
steady after voltage has increased, normally within 30
minutes.
If after one hour red light is still flashing, this indicates a
defective battery pack and should be replaced.
✒
20
24
Fig. 1
Fig. 2
BATTERY
PACK
BIT
STORAGE
TORQUE
ADJUSTMENT
RING
SWITCH
TRIGGER
BATTERY
CHARGER
TWO SPEED GEAR TRAIN (LO-HI)
KEYLESS
CHUCK
DIRECTION OF
ROTATION
SELECTOR
BATTERY
PACK
BATTERY
CHARGER
YELLOW LIGHT "ON" AND RED LIGHT
FLASHING INDICATES DEFECTIVE
BATTERY PACK
GREEN LIGHT "ON"
INDICATES FULLY CHARGED
OR IN SLOW CHARGING MODE
BIT STORAGE