Filter
Top Products
Page 11
20
24
OPERATION
Fig. 8
INSTALLING AND REMOVING BITS
■ Place the direction of rotation selector at the center
position. This will lock the switch trigger in the off
position.
■ Open or close the chuck jaws to a point where the
opening is slightly larger than the bit size you intend to
use. Also, raise the front of your drill slightly to keep the
bit from falling out of the chuck jaws.
■ Insert your drill bit into the chuck the full length of the
jaws.
See Figure 8.
■ Tighten the chuck jaws on the drill bit. To tighten, grasp
and hold the drill with one hand, while rotating the chuck
sleeve with your other hand.
Note: Rotate the chuck sleeve in the direction of the arrow
marked CLOSE to tighten the chuck jaws. DO NOT use a
wrench to tighten or loosen the chuck jaws.
WARNING:
Do not insert drill bit into chuck jaws and tighten as shown
in figure 9. This could cause drill bit to be thrown from
drill resulting in possible serious personal injury or
damage to the chuck.
REMOVING BITS
See Figure 8.
■ Place the direction of rotation selector at the center
position. This will lock the switch trigger in the off position.
■ Loosen the chuck jaws from drill bit
.
■ To loosen: grasp and hold the drill with one hand, while
rotating chuck sleeve with your other hand.
Note: Rotate chuck sleeve in the direction of the arrow
marked OPEN to loosen chuck jaws. DO NOT use a
wrench to tighten or loosen the chuck jaws.
■ Remove drill bit from chuck jaws.
DRILLING
See Figure 10.