Ryobi S650D Sander User Manual


 
Page 10
ORBITAL MOTION
Orbital motion is ideal for fast cutting action when removing
old finishes, smoothing rough wood, cutting stock down to
required dimensions, or for finishing surfaces to be painted.
As shown in figure 6, the sandpaper moves in tiny circles at
a very high speed, allowing the sander to move easily.
WARNING:
Collected sanding dust from sanding surface coatings
such as polyurethanes, linseed oil, etc. can self-ignite in
your sander dust bag or elsewhere and cause fire. To
reduce the risk of fire always empty your dust bag frequently
while sanding and never store or leave a sander without
totally emptying its dust bag. Also follow the
recommendations of the coatings manufacturers.
USING THE DUST BAG ASSEMBLY
The dust bag assembly provides a dust collection system
for the sander. Sanding dust is drawn up through the
holes of the sanding disc and collected in the dust bag
during sanding.
TO ATTACH THE DUST BAG ASSEMBLY
See Figure 7.
Follow these directions to attach the dust bag assembly.
Unplug the sander.
WARNING:
Failure to unplug the tool could result in accidental starting
causing possible serious injury.
Slide the dust bag assembly onto the blower exhaust on
the sander using a slight twisting motion.
TO EMPTY THE DUST BAG ASSEMBLY
See Figure 7 and 8.
For more efficient operation, empty the dust bag when it
is no more than half full. This will permit the air to flow
through the bag better. Always empty and clean the dust
bag thoroughly upon completion of a sanding operation
and before placing the sander in storage.
TO EMPTY DUST BAG
Unplug your sander.
WARNING:
Failure to unplug your sander could result in accidental
starting causing possible serious personal injury.
Remove the dust bag assembly from the sander.
Remove the dust bag from the frame.
Shake out the dust.
Replace the dust bag on the frame.
Replace the dust bag assembly on the sander.
Fig. 6
Fig. 7
ORBITAL MOTION
DUST BAG
ASSEMBLY
DUST BAG FRAME
Fig. 8
DUST BAG
OPERATION