Filter
Top Products
Page 13
OPERATION
Fig. 8
WARNING:
Do not allow familiarity with the drill-driver to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to fully charge.
TO CHARGE
See Figure 8.
■ Charge battery pack only with the charging assembly
provided.
■ Make sure power supply is normal household volt-
age, 120 volts, 60 Hz, AC only.
■ Connect charging assembly to power supply.
■ Place battery pack in charging assembly. Align raised
rib on battery pack with groove in charging assembly.
See
Figure 9
.
■ Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
assembly. When properly connected, red light on charg-
ing assembly will turn on.
Note: During the two year warranty period, if the charge
indicator light (LED) fails to come on or goes out while
charging battery pack, return charging assembly and
battery pack to your nearest authorized service center
for repair or replacing.
■■
■■
■ After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack. Note: If battery
pack is completely discharged, 6 hours or longer of
charging time is required to fully recharge battery
pack.
■ The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
■ DO NOT place charging assembly in an area of ex-
treme heat or cold. It will work best at normal room
temperature.
■ When battery pack has been charged, disconnect charg-
ing assembly from power supply and remove the bat-
tery pack. This practice will increase battery life.
CHARGING
ASSEMBLY
BATTERY
PACK
CHARGE
INDICATOR
LIGHT (LED)