Ryobi SA14402 Drill User Manual


 
Page 13
OPERATION
Fig. 8
WARNING:
Do not allow familiarity with the drill-driver to make
you careless. Remember that a careless fraction of a
second can result in a serious personal injury.
LED FUNCTION OF CHARGER
See Figure 8.
LED WILL BE LIGHTED TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
Red LED lighted = Fast Charging Mode
Green LED lighted = Fully Charged Battery Pack
Yellow and Green LED Lighted = Control Charge or
Defective Battery Pack.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to fully charge.
TO CHARGE
Charge battery pack only with the charger provided.
Make sure power supply is normal house voltage,
120 Volts, 60 Hz, AC only.
Connect charger to power supply.
Place battery pack in charger.
See Figure 9.
Align raised
rib on battery pack with groove in charger.
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
Normally, the yellow and green lights on the charger will
come on. This indicates charger is in control charge
mode and should switch to fast charge mode within 5
minutes. When charger is in fast charge mode the red
light will come on. If after a period of 15 minutes the
yellow and green lights remain on, remove the battery
pack, wait 1 minute and reinsert battery pack in charger.
If the yellow and green lights continue to remain on an
additional 15 minutes, the battery pack is damaged and
will not accept charge.
When your battery pack becomes fully charged, the red
light will turn off and the green light will turn on.
After normal usage, 1 hour of charge time is required to
be fully charged. A minimum charge time of 1 to 1-1/2
hours is required to recharge a completely discharged
tool.
The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
DO NOT place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
BATTERY
CHARGER
GREEN LIGHT "ON"
INDICATES FULLY
CHARGED
YELLOW AND GREEN LIGHTS "ON"
INDICATES CONTROL CHARGE OR
POSSIBLE FAULTY BATTERY
RED LIGHT "ON"
INDICATES FAST
CHARGING MODE
Fig. 9
BATTERY
PACK
BATTERY
CHARGER