Filter
Top Products
Page 14
5
1
0
5
1
0
Fig. 9
DIRECTION
OF ROTATION SELECTOR
SWITCH
TRIGGER
IMPORTANT INFORMATION FOR RECHARG-
ING HOT BATTERIES
When using your drill-driver continuously, the batteries be-
come hot. You should let the batteries cool down for approxi-
mately 30 minutes before attempting to recharge.
NOTE: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
occur under normal circumstances. Refer to “Charging Your
Drill-Driver” earlier in this manual, for normal recharging of
batteries. If the charger does not charge your batteries under
normal circumstances, return both the drill-driver and charger
to your nearest authorized service center for electrical check.
For more information on the battery recycling call
1-800-8 BATTERY.
WARNING:
If any parts are missing, do not operate tool until the
missing parts are replaced. Failure to do so could
result in possible serious personal injury.
TO INSTALL BATTERY PACK MODEL SA720
■■
■■
■ Place the direction of rotation selector in center posi-
tion.
See Figure 9.
■■
■■
■ Place the battery pack in your drill. Align raised rib on bat-
tery pack with groove in drill's battery port.
See Figure 10.
■■
■■
■ Make sure the latches on each side of your battery pack
snap in place and that battery pack is secured in drill
before beginning operation.
TO REMOVE BATTERY PACK MODEL SA720
■■
■■
■ Place the direction of rotation selector in center posi-
tion.
See Figure 9.
■■
■■
■ Locate latches on side of battery pack and depress both
sides to release battery pack from your drill.
See Figure
10.
■■
■■
■ Remove battery pack from your drill.
CAUTION:
When placing battery pack in your drill, be sure raised
rib on battery pack aligns with groove in drill's battery
port and latches snap in place properly. Improper
assembly of battery pack can cause damage to inter-
nal components.
Fig. 10
BATTERY
PORT
BATTERY
PACK
LATCHES
DEPRESS LATCHES
TO RELEASE
BATTERY PACK
OPERATION
MODEL SA720
REVERSE
FORWARD