Filter
Top Products
28
ADJUSTMENTS
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of pro-
cedures other than those specified herein can result in
hazardous radiation exposure.
TO ADJUST THE LASER GUIDE
See Figure 34.
Use the work clamp or a C-clamp to secure a piece of
scrap wood.
Plug the saw into the power source and make a slight
cut to score the wood.
Release the switch trigger and allow the saw blade to
stop rotating before raising the blade.
Raise the saw arm.
Unplug the saw.
Using the Phillips end of the supplied blade wrench, loosen
the laser adjustment screw and move laser assembly until
aligned.
NOTE: When properly aligned, the laser should be on the
left edge of the kerf.
Holding the laser assembly, tighten the laser adjustment
screw.
LASER
ADJUSTMENT
SCREW
Fig. 34
LASER
ASSEMBLY