Filter
Top Products
Page 26
30
45
1
2
3
4
5
6
7
8
9
1
0
1
2
1
2
1
2
1
2
1
2
1
2
1
2
1
2
1
2
0
CUTTING WARPED MATERIAL
See Figures 36 and 37.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 36.
If the warped material is positioned the wrong way as shown
in figure 37, it will pinch the blade near the completion of the
cut.
WARNING:
To avoid a binding condition and to avoid serious
personal injury, never position the concave edge of
bowed or warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 38.
When cutting wide workpieces, such as 6 in. x 2 in. (152 mm
x 51 mm), boards should be clamped with a C-clamp as
shown in figure 38.
OPERATION
Bevel
Angle Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save right end of cut
33.85
°
33.85
°
33.85
°
33.85
°
Fig. 36
RIGHT
WRONG
Fig. 37
Fig. 38
WIDE
BOARD