Schumacher 00-99-000985/1009 Welder User Manual


  Open as PDF
of 36
 
•7•
SPECIFICATIONS 2.3
Input Voltage 120 volt 60 Hz. Single Phase
Input Amps @ Rated Output 20 AAC
Input Plug Style 120 volt 15 amp
Power Cord Length 6-ft.
Rated Output Amps 70AAC
Max Output Amps 80 AAC
Rated Output Volts 27VAC
Rated Duty Cycle 10%
Max Open Circuit Voltage 40 VAC
Agency Listing cULus
Output Settings 2
POWER REQUIREMENTS 2.4
WARNING: THIS WELDING MACHINE MUST BE CONNECTED
TO A POWER SOURCE IN ACCORDANCE WITH APPLICABLE
ELECTRICAL CODES.
This welder intermittently draws more than 15 amps of current. We
recommend that you either install a 20 amp circuit or do not run anything
else on the same circuit as the welder or you may trip the breaker
supplying the AC power. If you modify the power cord in any way, other
than attaching the proper input plug, you will void the manufacturer’s
warranty.Itisrecommendedthataqualiedelectricianverifytheactual
voltageatthereceptacleintowhichthewelderwillbepluggedandconrm
that the receptacle is properly fused and grounded. The use of the proper
circuit size can eliminate nuisance circuit breaker tripping while welding.
DO NOT OPERATE THIS WELDER if the actual power source voltage is
lessthan100voltsACorgreaterthan125voltsAC.Contactaqualied
electrician if this problem exists. Improper performance, damage to the
welder, property damage and/or personal injury can result if operated on
inadequate or excessive power.
WARNING: ELECTRIC SHOCK CAN KILL! FIRE CAN KILL,
INJURE, AND CAUSE PROPERTY DAMAGE!
Toreducetheriskofelectricshockandre,connectonlyto •
properly grounded and fused outlets.
Never alter the AC power cord provided on the welder. Never •
alter an extension cord or extension cord plugs.
 previous next