Schumacher CBC-1000 Battery Charger User Manual


 
6
ASSEMBLY INSTRUCTIONS9.
No assembly required
OPERATING INSTRUCTIONS10.
This unit is a manual charger and care must be taken to prevent over-10.1
charging. Manual chargers will not shut off by themselves. While charging,
manual chargers must not be left unattended as severe battery damage
or other hazardous conditions may result. We recommend monitoring the
battery’s condition at 1 to 2 hour intervals until full charge is reached.
Follow all safety and operating instructions in this manual.10.2
Before connecting charger clips, make sure charger is removed from 10.3
electrical outlet.
When battery is installed in vehicle or equipment, follow connection 10.4
sequence in section 6. When battery is charged outside vehicle or equip-
ment, follow sequence in section 7.
Insert charger into electrical outlet.10.5
After charging is complete, disconnect charger, remove clip from vehicle 10.6
chassis and then remove clip from battery terminal. When charging battery
outside of vehicle or equipment, follow procedures covered in section 7.
MAINTENANCE INSTRUCTIONS11.
Before performing maintenance, unplug and disconnect battery charger 11.1
(see sections 6.7 and 7.6).
After use, use a dry cloth to wipe all battery corrosion and other dirt or oil 11.2
from terminals, cords, and the charger case.
Servicing does not require opening unit, as there are no user-serviceable 11.3
parts.
STORAGE INSTRUCTIONS12.
Store charger unplugged, in an upright condition. Cord will still conduct 12.1
electricity until it is unplugged from outlet.
Store inside, in a dry, cool place.12.2
Do not store clips on handle, clipped together, on or around metal, or 12.3
clipped to cables.
BEFORE RETURNING FOR REPAIR13.
When a charging problem arises, make certain battery is capable of ac-13.1
cepting a normal charge. Use a good battery to double-check all connec-
tions, AC outlet for full 120 volts, charger clips for correct polarity, and the
quality of connections from cable to clips and clips to battery system. Clips
must be clean.