Filter
Top Products
• 5 •
starting clamps and the USB port. Do not allow the clamps to touch each
other or the same piece of metal when the switch is “On” (turned to the
right).
Conrm that both jump starting clamps are stored on the storage holders, 9.1
or that the Quick Connectors are disconnected.
Turn the Jump Start + USB switch to “On” position.9.2
The USB plug is now live; plug in the accessory.9.3
USING THE AIR COMPRESSOR10.
PRECAUTION – Read instructions of the product being inated before
using the compressor. Avoid over ination, do not exceed the manufactur-
ers recommended pressures. DO NOT leave the compressor unattended
during use.
The 12 volt compressor is rated for 150 PSI pressure. The hose is stored
on the back of your Instant Power™.
The ON / OFF switch for the compressor is located on the back of the
Instant Power™.
Attach the air compressor hose to the product or accessory to be inated 10.1
by ipping down the lever.
Push the air compressor switch to the ON position and inate product.10.2
When the product is inated to the proper air pressure, push the compres-10.3
sor switch to the OFF position and remove the hose.
Do not run compressor for more than 10 minutes maximum at a time. Al-10.4
low the compressor to cool down for 10 minutes before using again.
NOTE: If the compressor overheats, the built-in thermal protection will turn
the unit off. Wait a few minutes and it will automatically restart.
Estimated Time for Inating
Vehicle 13” to 16” 3 to 16 Minutes
Bike Tire 30 to 40 Seconds
Balls 5 to 30 Seconds
Use an air compressor gauge to ensure the proper pressure has been
reached. Do not over inate.
USING LIGHT11.
Flip the Light Switch, located on the front of the IP-180KE, to the ON posi-11.1
tion.
NOTE: The LED lights are not replaceable.