Filter
Top Products
15
TROUBLESHOOTING
Performance problems often can be corrected by the user. Please read through this
chart for a possible solutions to common problems.
PROBLEM POSSIBLE CAUSE SOLUTION
The battery is connected The SpeedCharge is in Press the CHARGE RATE
and the charger is on, tester mode, not charger button to activate charging
but it isn’t charging. mode. and select a charge rate.
Indicator lights are lit in an The charger may be Return to place of pur-
erratic manner not defective. chase for replacement.
explained in the “Using
Your Battery Charger”
section. You might have Make sure nothing is
accidentally activated a touching the control panel,
special diagnostic mode. then unplug the unit and
plug it in again.
The CHECK (red) light This will happen if the Reset the charger by un-
always flashes before the battery did not reach full plugging it or briefly
battery is completely charge within 24 hours. disconnecting it or briefly
charged. May be due to a very disconnecting the negative
large battery or a bank of battery clip. Select the
batteries requiring more desired charge rate and
power than a 30/10 Amp battery type again, if
charger can deliver within necessary.
24 hours. The battery
may also be faulty.
Engine crank time is less Starter motor may be Charge the battery at the
than specified. drawing more than 60 30A
10A rate for 10 to
Amps. 15 minutes then crank the
engine.
The green CHARGED The battery may be fully If the battery is in a vehicle,
light turns on a few charged or recently turn the headlights on for a
minutes after connecting charged, leaving the few minutes to reduce the
to the battery. battery voltage high battery voltage and try
enough to appear to be charging again.
fully charged.
MAINTENANCE AND CARE
A minimal amount of care can keep your battery charger working properly for years.
1. Clean the clamps each time you are finished charging. Wipe off any battery fluid
that may have come in contact with the clamps to prevent corrosion.
2. Coil the input and output cords neatly when storing the charger. This will help
prevent accidental damage to the cords and charger.
3. Occasional cleaning of the case of the charger with a soft cloth will keep the finish
shiny and help prevent corrosion.