Schumacher SC-8020A Battery Charger User Manual


  Open as PDF
of 40
 
6
ASSEMBLY INSTRUCTIONS9.
Included with your battery charger are two cord wrap cleats for storage of 9.1
the clamp cables.
9.2
push until you hear a snap.
Wrap clamp cables after unplugging the power cord from the AC wall 9.3
outlet and store your charger in a dry location.
USING ENGINE START10.


IMPORTANT: -
ing your battery. Wear complete eye protection and clothing protection.
Charge your battery in a well-ventilated area.
IMPORTANT: Using the ENGINE START feature WITHOUT a battery
installed in the vehicle could cause damage to the vehicle’s electrical
system.
With the charger plugged in and connected to battery and chassis (see 10.1

LED is lit. The display mode will be automatically set to VOLTAGE.
10.2
wait 3 minutes before cranking again.
10.3
output clamps.
Clean and store the charger in a dry location.10.4
NOTE:10.5 
one of three states.
1. Wait for cranking - The charger waits until the engine is actually
being cranked before delivering 80 amps for engine start. The charger
delivers charge at a rate of up to 10 amps while waiting and will reset

 12V AGM BATTERY TYPE.)

(it can’t be set to percent.)
2. Cranking 
deliver up to its maximum output (at least 80A) as required by the
starting system for up to 5 seconds or until the engine cranking stops.
The digital display shows a countdown of the remaining crank time in
seconds. It starts at 5 and counts down to 0.
3. Cool Down

changed. The buttons are ignored. The digital display indicates the
 previous next