Filter
Top Products
M
O
UNTIN
G
IN
S
TRU
C
TI
O
N
Figure 1 illustrates the charger mounting brackets.
Figure 2 illustrates surface mounting of the charger to the
Fender well. If using the nut and bolt provided, drill two holes between
3/16" and 1/4" in diameter. (For alignment of holes use one of
the brackets as a template.) If the backside of the mounting
surface is hard to reach, you may consider using two 1/2" sheet
metal screws instead of nut bolt, drill a pilot hole if required, drill
holes between 1/8" and 5/32".
CAUTION:
Do not drill or puncture
battery.
Electrical installations - Route and secure supply cord and output wiring
away from gas line, carburetor or other hot, sharp or moving and pinch
parts to avoid damage to the insulation. Secure the AC cord and plug to
a cable or from using a self locking cable tie or equivalent.
Figure No. 3 illustrates mounting of the charger alongside the battery of
your automobile. If convenient place the charger to the side of the
battery away from the engine and fan blades, assemble the brackets as
shown in figure No. 4. Loosen the battery retaining hardware enough
that you can insert the longer portion of bracket "C" between the bottom
of the battery and the battery mounting tray. Align the charger to freely
stand without restrictions, then tighten all hardware.
ELECTRICAL CONNECTION
The output leads of the charger are terminated with 3/8 inch ring
lugs. Remove the bolts from the battery post connector, insert the bolt
through the ring lug then place the bolt back in the battery connector
and tighten. Connect the red lead to the positive (+) battery post and
the black lead to the negative (-) post.
If you have difficulty connecting the output leads, consult your
local auto supply store, they may assist you in finding a connecting
device for, your application.
LIMITED
WARRANTY
SCHUMACHER ELECTRIC CORPORATION, 7474 NORTH ROGERS AVENUE, CHICAGO, ILLINOIS 60626 MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED
WARRANTY IS NOT TRANSFERABLE.
Schumacher Electric Corporation warrants this battery charger for two years from date of purchase at retail against defective material or workmanship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer. It is
the obligation of the purchaser to forward the unit together with proof of purchase, transportation and/or mailing charges prepaid to the manufacturer or its authorized representative.
This limited warranty is void if the product is misused, subjected to careless handling, or repaired by anyone other than the manufacturer or its authorized representative.
The manufacturer makes no warranty other than this limited warranty and expressly excludes any implied warranty including any warranty for consequential damages.
THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES ANYONE TO ASSUME OR MAKE ANY OTHER OBLIGATION TOWARDS THE PRODUCT OTHER THAN THIS
EXPRESS LIMITED WARRANTY THE MANUFACTURER MAKES NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE OF THIS PRODUCT AND EXPRESSLY EXCLUDES SUCH FROM THIS LIMITED WARRANTY.
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LENGTH OF IMPLIED WARRANTY SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.