Filter
Top Products
ADJUSTING THE BLADE SQUARE
TO TABLE
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF", REMOVE KEY AND REMOVE
PLUG FROM POWER SOURCE OUTLET.
1, WITH BLADE INSTALLED AND TENSIONED
place combination square on side of blade,
Guard prevents placing square directly against
blade, so gauge squareness of blade to table by
viewing from side of saw,,
GUARD
BLA[
COMBINATION
SQUARE
HOUSING
2 If an adjustment is necessary, foosen four (4) hex
bolts located at back of lower arm on saw using
7/16" wrench. Align blade square to table by
tilting housing forward or backward, and
retighten all four (4) bolts
NOTE: Make certain the blade is centered in the
insert opening Readjust if necessary by
loosening four hex head bolts and moving
housing to center the blade Retighten bolts
HEX HEAD BOLTS
3 Place square in front of blade Guard prevents
placing square directly against blade, so gauge
squareness of table to blade by viewing from front
of saw
4 If an adjustment is necessary, loosen bevel lock
knob located under base and rotate housing
slightly to align blade to combination square
Tighten bevel lock knob
J
BEVEL LOCK KNOB
HOUSING
BEVELLOOK
NOB
BLADE _
CO ,¢2#,ON
F
13