Filter
Top Products
6
Sears 210 - Sch 50911/13/95
Using YUsing Y
Using YUsing Y
Using Y
our Battery Chargerour Battery Charger
our Battery Chargerour Battery Charger
our Battery Charger
For best results from your battery charger, learn to use it properly. This section tells how to set the controls and how
to charge a battery in or out of the vehicle.
▲▲
10 AMP 2 AMP
Setting the Controls
SELECTOR SWITCHES:
A 2-way switch is used to select the 2-AMP or the
10-AMP charge rate.
AMMETER:
The AMMETER indicates the measured amount of amperes
being drawn by the battery. When you first start charging a
battery, the reading will be high, with the needle near 10 using
the 10 amp charging rate. As the battery charges, the needle
will fall to about 4 or 5 amps, indicating a charged battery.
At the 2 amp charging rate, as the battery charges the
needle will fall to about 3/4 to 1 amp indicating a charged
battery.
Charging Your Battery
Charging a battery in the vehicle:
1. Arrange the power cord and charging leads carefully
to avoid damage that could be caused by the hood,
door, or moving engine parts.
2. Keep clear of fan blades, belts, pulleys, and other
parts that can cause injury.
3. Check the polarity of the battery posts as indicated
on the battery case: POSITIVE (POS, P, or +) and
NEGATIVE (NEG. N or -). NOTE: The positive post
on top-post batteries is usually larger than the
negative post.
4. Identify which battery post is ground or connected
to the chassis. THE NEGATIVE POST IS
NORMALLY THE ONE THAT IS GROUNDED.
5. To charge a negative grounded post system:
Connect the red (POSITIVE) battery charger clamp
to the ungrounded POSITIVE (POS, P, +) post of the
battery. Then connect the black (NEGATIVE) clamp
to a heavy, unpainted metal part of the chassis or
engine block, away from the battery. Do not connect
clamp to carburetor, fuel lines, or sheet metal parts.
To charge a positive grounded post system:
Connect the black (NEGATIVE) battery charger
clamp to the NEGATIVE (NEG, N, -) ungrounded
post of the battery. Then connect the red
(POSITIVE) clamp to a heavy, unpainted metal part
of the chassis or engine block. Do not connect
clamp to carburetor, fuel lines, or sheet metal parts.
IMPORTANT: Wear safety glasses and face away
from the battery while making connections.
The percent of charge scale is intended as a visual aid to
help simplify reading the state of charge of the battery. The
meter is scaled for use with the 10 amp charge rate only.
For the 2 amp charge rate use the red triangle. The percent
of charge is based on current drawn by the battery. For this
reason accuracy will vary with the size and battery type.
NEGATIVE GROUNDED SYSTEM