Filter
Top Products
inseconds.Itstartsat5 andcounts
downto0.
3.CoolDown-Aftercranking,thechar-
gerentersamandatory3-minute(180
second)cooldownstate.Duringthis
period,nosettingscanbechanged.The
buttonsareignored.Thedigitaldisplay
indicatestheremainingcooldowntime
inseconds.Itstartsat180andcounts
downto0.The125ASTARTLEDblinks
onceeverysecond.Duringthecool
downperiod,nocurrentisdeliveredto
thebattery.After3 minutes,the125A
STARTLEDwillstopblinkingandwilt
lightcontinuously,indicatingthatan-
othercrankcyclecanbestarted.The
digitaldisplaywillchangefromdisplay-
ingthecountdownbacktodisplaying
thebatteryvoltage.TheCHARGING
LEDwillbelitagain.
ENGINE STARTING NOTES:
• If the battery is disconnected during
the cool down period, the charger wilt
reset.
OVERVIEW
Using this battery charger is very simple.
First, connect the battery and AC power
following the precautions listed under
"OPERATING INSTRUCTIONS". Then
select the appropriate CHARGE TYPE and
CHARGE RATE for your battery. The char-
ger will then do everything automatically.
This section explains a few details.
CHARGING: If the charger does not
detect a properly connected battery, the
CHECK (red) LED wilt light continuously
until such a battery is detected. Charging
will not begin while the CHECK LED is on.
When charging begins, the CHARGING
LED will be lit.
AUTOMATIC SHUT OFF: When the 2A,
15A or 40A charge rate is selected, the
charger is set to perform an automatic
charge. When an automatic charge is
performed, the charger stops charging
automatically after the battery is charged.
ABORTED CHARGE: If charging can't
be completed normally, charging will be
aborted. When charging is aborted, the
charger's output is shut off and the red
CHECK LED and digital display blink on
and off (at opposite times). Inthat state, the
charger ignores all buttons. To reset from
after an aborted charge, either disconnect
the battery or unplug the charger.
DESULFATION MODE: If a battery is
left discharged for an extended period, it
could become sulfated and not accept a
normal charge. If the charger detects a
sulfated battery, the charger will switch to
a special mode of operation designed for
such batteries. Activation of the special
desulfation mode is indicated by blinking
the CHARGING LED. If successful, nor-
mal charging will resume after the battery
is desulfated. The CHARGING LED will
then stop blinking and light continuously.
Desulfation could take up to 10 hours. If
desulfation fails, charging will be aborted
and the CHECK (red) LED will blink.
COMPLETION OF CHARGING: Charge
completion is indicated by the CHARGED
(green) LED; when tit, the charger has
stopped charging and switched to the
Maintain Mode of operation, if the DEEP
CYCLE charge type was selected. For
other charge types, the CHARGED LED
comes on when the battery is charged
enough for normal use.
MAINTAIN MODE: When the CHARGED
(green) LED is tit, the charger has started
Maintain Mode. This mode of operation is
also known as Float-Mode Monitoring. In
this mode, the charger keeps the battery
fully charged by delivering a small current,
when necessary. The voltage ismaintained
at a level determined by the CHARGE
TYPE selected. NOTE: For charge types
other than DEEP CYCLE, the CHARGED
LED might be lit before Maintain Mode is
started.
GENERAL CHARGING NOTES: The
charger is designed to control its cooling
fan for efficient operation. Consequently, it
is normal for the fan to start and stop when
maintaining afully charged battery. The fan
does not run in Tester Mode.