Filter
Top Products
installation Instructions (continued)
GENERAL
= See Dimensions and Clearances on page 2 for all
rough-in and spacing dimensions. These dimensions
must be met for safe use of your range. The location of
the electrical outlet and pipe opening shown on page 5
may be adjusted to meet specific requirements°
• The range may be placed with 0" clearance (flush) at
the back wall and side walls of the range.
LOCATION
Do not locate the range where it may be subject to
strong drafts. Any openings in the floor or wall behind
the range should be sealed. Make sure the openings
around the base of the range that supply fresh air for
combustion and ventilation are not obstructed by car-
peting or woodwork.
PROTECT YOUR FLOOR
Your range, like many other household items, is heavy
and can settle into soft floor coverings such as cush-
ioned vinyl or carpeting° Use care when moving the
range on this type of flooring. It is recommended that
the following simple and inexpensive instructions be
followed to protect your floor.
The range should be installed on a sheet of plywood
(or similar material) as follows: When the floor cover-
ing ends at the front of the range, the area that the
range will rest on should be built up with plywood to
the same level or higher than the floor covering. This
will allow the range to be moved for cleaning or ser-
vicing.
MODEL AND SEROALNUMBER LOCATION
The model and serial numbers are on a label located
on the front frame of the range, behind the kick panel
TOOLS YOU WILL NEED
• Phillips screwdriver
° Pencil and ruler
o Two pipe wrenches (one for backup)
° 1_/8"open-end or adjustable wrench
° 3/16" open-end or socket wrench
• Nut driver
In addition, for LP gas conversion, you will need:
° 5/16" open-end wrench
• 1/2" opemend wrench
ADDITIONAL MATERIALS YOU MAY NEED
° Gas line shutoff valve
° Pipe joint sealant or pipe thread tape with Teflon*
that resists action of natural and LP gases
° Flexible metal appliance connector (1/2" I.D.). A 5-
foot length is recommended for ease of installation but
other lengths are acceptable. Never use an old con-
nector when installing a new range.
• Flare union adapter for connection to gas supply line
(3/4" or t/2" NPT x 1/2" I.D)
o Flare union adapter for connection to pressure regu-
later on range (112" NPT x 1/2" ID.)
"Teflon: Registered trademark of DuPont
PREPARATION
• Remove all tape and packaging. Be sure to remove
plastic film that covers some chrome parts (around
oven doors, side trim).
o Take the accessory pack out of the oven.
° Check to be sure that no range parts have come
loose during shipping..