Filter
Top Products
12
SAFETY PARTSTROUBLESHOOTINGOPERATION MAINTENANCE
To keep your battery charger working properly for years:
MAINTENANCE AND CARE
Example: 15 Amp-Hour (AH) Battery, 50% State-of-Charge,
2 Amp Charger Setting
[(AH x Charge Factor) ÷ Charger Setting] x 1.25 = Hours Needed
(15 x 0.5 ÷ 2) x 1.25 = 4.7 Hours
Charge Time Needed if Reserve Capacity is Known
• Find the Charge Factor for your battery in the table on page 11.
• Multiply by the Reserve Capacity rating of the battery.
• Divide by the Charger Setting (either 2 Amp or 12 Amp).
• Multiply by 0.73 to get the approximate
Hours Needed
to bring the battery to
full charge.
Example: 95-Minute Reserve Capacity (RC) Battery, 25%
State-of-Charge, 12 Amp Charger Setting
[(RC x Charge Factor) ÷ Charger Setting] x 0.73 = Hours Needed
[(95 x 0.75) ÷ 12] x 0.73 = 4.3 Hours
Charge Time Needed if Amp-Hours is Known
• Find the Charge Factor for your battery in the table on page 11.
• Multiply by the Amp-Hour rating of the battery.
• Divide by the Charger Setting (either 2 Amp or 12 Amp).
• Multiply by 1.25 to get the approximate
Hours Needed
to bring the battery to full
charge.
1. Clean the clamps each time you are
finished charging. Wipe off any
battery fluid that may have come in
contact with the clamps to prevent
corrosion.
2. Coil the input and output cords neatly
when storing the charger. This will
help prevent accidental damage to
the cords and charger.