Filter
Top Products
NOTES
This manual contains information for the proper assembly,
operation and care of your SP150 sprayer. Carefully read and
follow the instructions contained in this manual before operating
your sprayer.
Specifications
Unpack the following items shipped in your sprayer box:
■ Wand
■ Tank Assembly
■ Owner’s/Operator’s Manual
Net Weight .......................................................3.6 pounds (1.65 kg)
Tank Capacity ...........................................1.3 U.S. gallons (5 liters)
Tank Material ...............................................................Polyethylene
Fill Opening Diameter ......................................1.8 inches (45 mm)
Pump Type/Material .....................................Piston/Polyethylene
Operating Pressure ...........................10-45 psi (0.7-3.15 kg/sq.cm)
Wand Assembly Length ............................27.5 inches (698.5 mm)
Hose Length ...................................................59 inches (1500 mm)
Nozzle Installed .............................................. Red Adjustable Cone
Specifications subject to change without notice.
Prepare to AssembleIntroduction
Push the wand into the trigger valve and secure with screw
cap. Hand tighten to prevent leakage.
CAUTION!
Do not overtighten!
Trigger
Valve
Wand Screw Cap
Assembling the Spray Wand
IMPORTANT!
After assembling the sprayer, fill the tank with clear water, and
lay it on its side. Check for leaks. Return sprayer to its upright
position. Pump the sprayer 10-40 times or until the pressure
relief valve is released and check for leaks. Most leaks can be
stopped by tightening the appropriate connection or fitting. Any
leaks must be stopped prior to filling the sprayer with chemi-
cals.
Wand
Nozzle
Trigger
Valve
Tank
Pump Handle
Cylinder
Cap
Carry
Strap
Lid
Pressure
Relief Valve
WARNING!
Always relieve pressure from the sprayer tank by pulling the
pressure relief valve before removing the tank lid.
1