3
Push the wand into the trigger valve and secure with screw
cap. Hand tighten to prevent leakage.
CAUTION!
Do not overtighten!
Trigger
Valve
Wand Screw
Cap
Assembling the Spray Wand
Adjustment
Ring
Buckle
Tightening
1. Place the sprayer on
your back with the
staps loosened.
2. Hold the adjustment
ring firmly and pull
until backpack is
secure in place.
Loosening
Lift up on the buckle to release tension.
Adjusting the Shoulder Straps
IMPORTANT!
After assembling the sprayer, fill the tank with clear water and
lay it on its side. Check for leaks. Return sprayer to its upright
position. Pump the lever 10-15 times and check for leaks.
Most leaks can be stopped by tightening the appropriate
connection or fitting. Any leaks must be stopped prior to filling
the sprayer with chemicals.
1. Loosen the pump lever bolt and slide pump lever off of the
pump shaft linkage.
2. Move the pump lever to the opposite side of the sprayer tank
and install onto the pump lever shaft linkage as shown.
Bolt
Pump Lever
Shaft
Pump
Lever
Washer
Connecting
Rod
Retainer
Changing Lever Operating Side
WARNING!
Remove all chemicals and wash the sprayer thoroughly
before beginning to change the lever operating side.
Pump
Chamber
NOTE:
The operating lever may be mounted on the left or right side of
the sprayer tank depending on operator preference.
Nut
3. Tighten pump lever bolt securely.
IMPORTANT!
Make sure that the pump lever is installed so that full up and
down movement of the pump chamber is available.