Filter
Top Products
-10-
D2057A, D2058A, D2260A Mobile Base Instructions
11. With the help of an assistant, lift the rear side of
the machine up, then place a 4x4 block under the
machine.
12. Slide each of the corner brackets onto the remaining
rail, slide the assembly into the rails, over the block
and up against the machine, as shown in Figure 24.
Figure 24. Fixed casters and rail placed
around back of machine, which is raised
up with a wood block.
13. Secure each end of the rails to the corner brackets
with (2) M8-1.25 x 25 hex bolts and 8mm lock nuts,
as shown in Figure 25.
Note: Thread the hex bolts into the rails but do
not tighten the lock nuts against the rails until
instructed.
14. Remove the rear rail corner bracket assembly from
the 4x4 block.
15. While the assistant steadies the machine, remove
the 4x4 block, then set the machine on the ground.
16. Put on safety glasses, then use a crowbar and some
type of fulcrum to raise one of the side rails that is
attached to the front corner bracket assembly. Place
a 6" 2x4 under the rail to support it, as shown in
Figure 26.
17. Repeat Step 14 to place another 6" 2x4 under the
rail on the opposite side of the mobile base.
18. Carefully lean the machine toward the front of the
mobile base, making sure there are no large gaps
between the machine and the front rail corner
bracket assembly.
Figure 25. Rear rail fixed caster assembly
secured.
Figure 26. 2x4 placed under rail after
using crowbar to raise rail up.
Front Rail-Caster
Assembly
6" 2x4
12" 4x4
x 2 x 2