Filter
Top Products
-8-
D2057A, D2058A, D2260A Mobile Base Instructions
Assembling Base Around Machine
1. Thread a knob several turns into each foot post, as
shown in Figure 17.
2. Insert a foot into the bottom of each foot post (see
Figure 17). The magnetized knob shaft should pick
up the foot when it comes in close proximity.
Figure 18. Rail inserted between corner
brackets with knobs and feet.
Figure 19. Rail secured to brackets.
x 2
x 2
Corner Brackets
with Knob
Side Rail
Figure 17. Installing foot and knob into a
foot post.
Knob
Foot Post
Foot
3. Slide a side rail inside each of the two corner
brackets with the foot posts, then slide the assembly
up against the front of the machine or the side that
will be pushed (see Figure 18).
4. Move the corner brackets as close to the machine
base as possible.
5. Thread (1) 8mm lock nut halfway onto each M8-1.25
x 25 hex bolt with the nylon insert on the nut facing
the head of the bolt.
6. Secure each end of the rails to the corner brackets
with (2) M8-1.25 x 25 hex bolts and 8mm lock nuts,
as shown in Figure 19.
Note: Thread the hex bolts into the rails but do
not tighten the lock nuts against the rails until
instructed.